Anderson SB175 on Front & Rear

Does anyone have Anderson SB175 connectors on either the front or rear of their Tundra? I am looking for photos that show how they are mounted.

I've not found a lot of brackets for the SB175, and options for the rear of my '21 CM seem limited. Mounting one on the front will be easier as the DrawTite receiver I purchased has a lot of available surface area and it's all nice and square, whereas the factory receiver in the back is round, and most of it is covered by the plastic bumper. Coiling it up underneath is likely an option, too, but I'd rather not.

JamdonGear makes a variety of 3D-printed brackets and this Wits End site has some, too.

Thanks in advance for any photos or ideas. Hoping to place this close to the center and not cut or drill much, if at all.

 

Answering myself here for the benefit of future searchers... this is an '01 (I think) and I don't think the same approach works on a '21.

 

Have you checked powerwerx.com I use them for my mounting supplies.