1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Abs

Discussion in '2nd Gen Tundras (2007-2013)' started by Carpics557, Oct 31, 2023.

  1. Oct 31, 2023 at 2:12 PM
    #1
    Carpics557

    Carpics557 [OP] Carpics55-77

    Joined:
    Dec 31, 2022
    Member:
    #89531
    Messages:
    17
    Gender:
    Male
    First Name:
    Izac
    Vehicle:
    2007 silver RCLB 4x4 with a 4.7l v8
    Rims, tail lights, headlights, aftermarket radio,bullbar/w light bar. Curved light bar on roof and tow mirrors.
    Ok so a while ago I replaced my front abs sensors but they were cheap they were about 50 for two and obviously I knew there was a chance they would not do anything and I was right after they were replaced my break light came on. So after a few months I finally got good sensors and that turned off my break light. But my abs vsc off and 4lo lights are still on. Before I had all of thoes and my 4HI on but I fixed my rear one it just needed to be rewired. But I can’t seem to figure out why my abs, vsc off and 4lo are still on. Any suggestions
     

Products Discussed in

To Top