1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

4.7 vs 5.7 drive shafts

Discussion in '2nd Gen Tundras (2007-2013)' started by AZ Crewmax, Dec 30, 2024.

  1. Dec 30, 2024 at 11:06 PM
    #1
    AZ Crewmax

    AZ Crewmax [OP] New Member

    Joined:
    Dec 30, 2024
    Member:
    #128129
    Messages:
    4
    Gender:
    Male
    Vehicle:
    08 Crewmax
    I've searched and couldn't find an answer.

    Does anyone know or have experience with the 4.7 and 5.7 4x4 rear drive shafts. I've measured the flanges, bolt hole spacing, pilot, overall length etc and everything adds up but for some reason they have different part numbers.

    The 4.7 is 37100-0C170 and the 5.7 is 37100-0C150

    Has anyone installed a 4.7 shaft in a 5.7 vehicle? Thanks!
     
  2. Dec 30, 2024 at 11:52 PM
    #2
    MadMaxCanon

    MadMaxCanon New Member

    Joined:
    May 27, 2021
    Member:
    #63566
    Messages:
    4,347
    Gender:
    Male
    SoCal
    Vehicle:
    '21 CM SR5 4x4 6 seater
    Too many, but not enough....
    Different part numbers maybe because one has zerks and the later years dont?
     
  3. Dec 31, 2024 at 1:27 AM
    #3
    AZ Crewmax

    AZ Crewmax [OP] New Member

    Joined:
    Dec 30, 2024
    Member:
    #128129
    Messages:
    4
    Gender:
    Male
    Vehicle:
    08 Crewmax
    That's a good thought!
     

Products Discussed in

To Top