1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2012 Sequoia cranking but not starting after battery replacement

Discussion in '2nd Gen Tundras (2007-2013)' started by bizbeagan, May 19, 2023.

  1. May 19, 2023 at 4:44 PM
    #1
    bizbeagan

    bizbeagan [OP] New Member

    Joined:
    May 19, 2023
    Member:
    #97250
    Messages:
    1
    Gender:
    Male
    Vehicle:
    2012 Sequoia
    Battery got completely drained when ignition was left on over night and the battery wouldn't take a jump. Put in brand new 27F interstate thinking that would solve the problem but now the Sequoia will crank repeatedly, almost starts but then cuts back out, and continues cranking.

    https://youtu.be/TY6UslJgXao

    I've thoroughly cleaned the battery connectors but it didn't seem to make a difference.

    Sequoia was working fine up until this.

    Could this situation have causes something else to go with the swapping out the battery and repeatedly trying to start?

    I did check fuel pump fuse as a next step but haven't taken it any further.

    Any thoughts or suggestions greatly appreciated.
     
    Last edited: May 19, 2023

Products Discussed in

To Top