1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2008 Tundra

Discussion in '2nd Gen Builds (2007-2013)' started by Jhack, Jun 25, 2023.

  1. Jun 25, 2023 at 9:48 AM
    #1
    Jhack

    Jhack [OP] New Member

    Joined:
    Jun 25, 2023
    Member:
    #99186
    Messages:
    10
    Gender:
    Male
    First Name:
    Joel
    Vehicle:
    2008 Tundra
    My 4wheel drive has quit working. I have taken the actuators out and they are in brand new condition and working. When I turn the knob to put in 4 hi /lo, it just blinks and 4 wheel will not engage. The vacuum line is good as far as I can see. At first it wasnt working right because my wheel sensor went out due to a bad bearing. All has been replaced. Any suggestions?
     

Products Discussed in

To Top