1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2007 strut assembly replacement

Discussion in '2nd Gen Tundras (2007-2013)' started by neckbone, Aug 19, 2018.

  1. Aug 19, 2018 at 3:11 PM
    #1
    neckbone

    neckbone [OP] New Member

    Joined:
    Aug 19, 2018
    Member:
    #18338
    Messages:
    1
    Gender:
    Male
    hey guys...I recently changed the struts and coils (driver and passenger side). bought as a whole unit, used Monroe quick strut. job was a bi#$h but got it done. after I was finished I drove around the block just to make sure nothing was gonna fall off. LOL...anyway I decided to measure each side from the bottom of the finder well to a point on the tire. the driver side measures about 3/4-1" lower than the passenger side. when I brought it to the local mechanic to get the front aligned I asked them to double check the install. they said everything looked good. so with the driver side 3/4-1" lower is this normal/ok or do I need to look for a problem. by the way I do have 2" spacers in the front. thanks in advance for any feed back.
    -2007 tundra DC
    -87,000 mi
    -5.7 L
    -305/12.50/20 ridge grapplers (brand new)
     

Products Discussed in

To Top