2007-2010 tundra 4wd engine room measurements

Hi group, I am looking for the measurement graphs, but so far was unable to find it, maybe anyone has it?

Thanks in advance

p.s. I have a repair manual, but there is no dimensions in the manual so that I could use it to install radiator support

 

You gonna transplant something different in there?

 

Nothing different, I am installing a new radiator support, want to make sure it is installed properly

 

Swing by a body shop, collision repair places will have values for alignment holes.

This may seem overkill but mounting the fenders and hood will tell you a lot especially once you start making diagonal measurements for square news.

If fender to door gaps and hood to fender gaps are good it's likely close, but your repair sounds a like actual values would be helpful.

I've never looked on Toyotas TIS site for this, but it may be there?? It cost you a 3 day subscription.

 

Thanks, I just installed the new radiator support, all lines came up pretty well. all assignments are symmetric from both sides.

One more thing, I was not able to find measurements on the TIS website either