Fuel Pump Control Module Connector

Howdy alll,

After a crank no start issue I traced the problem back to a bad connection between the FPCM and the harness. A previous owner had spliced in new connections between the two smaller wires. One failed due to corrosion. I was able to reconnect it and she runs. The connection I made didn’t allow me to properly weather seal as I did not have enough wire. My question is does anyone offer an aftermarket male connector for this application? I guess the other route is to go to a junkyard. It’s also my understanding that there’s a relocation kit available for the FPCM.

Thanks for any and all help.

 

Here is what I could find. If it were my truck I would take a picture of the connector and contact Corsa Technic or Ballenger Motorsports and see if they can identify it. I wasn't able to find it listed. Pretty much all the connectors on these trucks are Denso, Sumitomo, or Yazaki.

Parts you can get from Toyota for a repair. If you can wait ordering these from Amayama or Partsouq might be cheaper than a Toyota dealer in the US.
Connector body: 90980-12785
Repair wire: 82998-24420 and 82998-12790

The repair wire is a 500mm length of wire with the correct terminals crimped on. Search R11 in this
https://www.tundras.com/attachments...6-4-connector-data-p-zz-lowercase-pdf.531535/

EDIT:
Found the terminals you would need to make your repair wires
https://www.corsa-technic.com/item.php?item_id=435

 

Thanks for this. The factory repair wire and terminals are something like $30 a piece. The factory connector is about $29.

I’ll order the factory connector and the pins you suggested. I’ll sort out the wire myself.