2007 tundra vsc off flashing 4 lo flashing and traction picture

Hello , a few weeks ago i was in branson mo and my asc off 4lo lights were falshing but would only let me go like 30 mph (limp) mode, in the end i had the part replaced and it cost me 1500 bucks and i made it back home . Now my 4lo vsc off and traction picture lights are flashing and im hoping someone can help me with this because i cant afford another big part replacement and i cant drive it all the way back to that mechanic. If anyone has an idea of what this could be please give me a shout . Thanks

 

Please someone if have any ideas on this would greatly appreciate it . Thank you

 

If I remember correctly, I had these lights when I hit a deer and it snapped off one of the connectors to the wheel speed sensor/abs etc wiring harness. They may have damaged the wire or it wasn't plugged in all the way.

 

You didnt say which part you had replaced, or either I couldnt make out which part you had replaced. Have you tried disconnecting the battery for a few minutes and connecting back?

Make sure you are in 2 wheel drive. I know that seems obvious, but double check.

Someone on here has a chart that indicates what the flashing lights mean. I looked but I dont have it. Maybe someone will post it.

 

can't help you if you don't know the code

 

A note of reference here. I recently had my ABS and T.C. lights on with flashing 4 hi / 4lo lights.
I started reading possible solutions and thought oboy, chasing problems here, dealership trip$$$.
I did try swapping speed sensors, checking fuses, when I thought I'd take another look at the wiring to the speed sensors.
Lo and behold the drivers rear speed sensor had one small wire severed. I removed the outer connector and was able to temporarily twist the small wires together. I was excited when I started the truck and the 4hi/4lo were OFF. THe ABS and traction control were still on. When I backed out and drove about 50 yds those lights disappeared also. I GOT LUCKY.
Upon inspecting the wire near the connector, I found corrosion (ten Iowa winters) .
JUst putting this out there for somebody else who has this problem. I was fortunate to find the severed wire.

 

Several weeks ago my 2007 tundra 4x4 with the 4.7 went into limp mode with the VSC, 4 low, and check engine light on. I pulled a code P2432 (secondary air injection/pressure sensor). I decided to install the Hewitt Bypass Kit to eliminate the possibility of this problem coming back. The installation was easier than I expected and after clearing the code, everything is good.