1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Natika backup Camera blurry/flickery image

Discussion in '1st Gen Tundras (2000-2006)' started by Dblock500, Jun 30, 2025 at 5:53 AM.

  1. Jun 30, 2025 at 5:53 AM
    #1
    Dblock500

    Dblock500 [OP] New Member

    Joined:
    Jan 23, 2025
    Member:
    #129280
    Messages:
    339
    Gender:
    Male
    DMV
    Vehicle:
    2002 SR5 AC 4.7 V8 4WD
    Spent all morning yesterday setting up a natika backup cam. Wasn't fun to run the wire with woolwax on the frame. Turns out the image isn't focused and is very blurry and has noise/static on the video feed when the engine is running only. When the engine is off, the static image goes away but the video picture is still blurry. Its not blurry from a dirty lens or a plastic lens cover from the orignal packaging. I used posi taps to tap into my reverse light's power (red w/blue stripe wire) and ground (brown &white wire) to the natika's wires. These are the taps I used, I'm concerned it likely needs a better ground? Posi-Tap Red (10) Inline Wire... https://www.amazon.com/dp/B01HSBYX3I?ref=ppx_pop_mob_ap_share

    All connections are on solid and the taps are screwed in as tight as it can go.

    The Natika manual says some US and German cars need a 12v dc power filter rectifier to fix similar issues.

    20250629_192003.jpg
     

Products Discussed in

To Top