1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Warn evo control box relocation

Discussion in 'Recovery & Gear' started by Sleeper16plat, Jun 10, 2025 at 11:34 AM.

  1. Jun 10, 2025 at 11:34 AM
    #1
    Sleeper16plat

    Sleeper16plat [OP] New Member

    Joined:
    Mar 18, 2020
    Member:
    #44073
    Messages:
    324
    Gender:
    Male
    Near Vancouver
    Vehicle:
    2016 Silver Platinum
    TRD Rear Sway Bar Bilstein 6112/5160 Pop Lock, Kenwood MX 1057 XR, Pioneer amp/speakers/subs, Tech12Volt dual sub box
    I am expecting delivery of a new front bumper this month and in anticipation of the install I want to prep the wiring to relocate the control box for a warn evo 10s winch. I can’t seem to get a straight answer on the gauge of wire I should use. The more I search and read the more confused I get. I believe I should use 2/0 gauge wire and I understand this is not the same as 2 awg gauge. So my question is what gauge wire should I order?
     
  2. Jun 11, 2025 at 2:32 PM
    #2
    Sleeper16plat

    Sleeper16plat [OP] New Member

    Joined:
    Mar 18, 2020
    Member:
    #44073
    Messages:
    324
    Gender:
    Male
    Near Vancouver
    Vehicle:
    2016 Silver Platinum
    TRD Rear Sway Bar Bilstein 6112/5160 Pop Lock, Kenwood MX 1057 XR, Pioneer amp/speakers/subs, Tech12Volt dual sub box
    Did some more searching, going to go with 1/0 gauge wire. I’ll let you know how it goes after the install and control box relocation.

    IMG_3561.jpg
     

Products Discussed in

To Top