RSI Smart Cap

RSI does not give discounts

 

We don't have tax and offer free shipping if that helps.

 

I installed my smart cap about 5 or 6 weeks ago. Assembled myself and had 3 friends help me lift it in place. Overall a easy install process. I've only put a few hundred miles on since then as I have a work truck and never put a lot of mile on my personal truck. After about 100 miles I went over all bolts and torqued again to spec. Over all I am very pleased. Built tough and looks great. Yesterday we had rain all day and when I got gome from work I checked out the inside. Not flooded but more leaks then I'd like. As mentioned in previous posts, I had to trim the gasket for the auto tailgate to work. No leaks there. Main leaks I'm concerned with are the slide window in the side doors seems to leak. I found water droplets on some of the bolts for the vent plate. However the filter for dust was dry. Lastly, the seam between the front panel and the 3 roof panels leaks. The roof panel seams and rear panel seam all are good. My thinking is loosen the vent bills and add some silicone around them to seal. As for the front panel leak, bead of silicone across the top of the seam to seal? I use rtv sealant often for refrigerator repairs at work. Not sure how this would hold up to heat and outdoor elements though. Any recommendations on silicone that is black so it blends in better and will be durable? Any recommendations on the slide window leaks? Overall I really like this cap and just wanna work the small leaks out.

 

I see RSI has two widths for load bars. Is it the 55” or 48”. Taking delivery soon and trying to get load bars soon.

 

For a Tundra you would want the 55's but they have been out of stock for months. We use these:
https://mikescustomtoys.com/product...-pickup-load-bar-kit-1345mm-w-by-front-runner

 

Are these in stock at your shop?

 

Just checked and we are out of that length but I can ship a set to you straight from front runner. Free shipping with code: SHIPPY250

 

cool I’ll take a look. Thanks!

 

Anyone have weird gasket overlap with the 3 piece roof?
I just got an evo sport 5.5 ft bed and the center roof panel has gaskets on the sides that also wrap around the ends.
The smaller side roof panels have gaskets at the sides that mate with the center panel but these are only at the ends of the panel and also wrap around the corners.This looks like it will create a gap even when everything is tightened down.

Also none of the images or videos look the way this does.



Thanks!

 

As long as the gaskets don't end at a connector it will be fine.

 

Thanks.
Do you mean like this?
This is on the tailgate side.

 

Exactly. That looks good.

 

Great!
Thanks. None of the instructions or videos show no gasket on those parts.

 

Just a heads up looks like an across the board 5% price increase set for Midnight.

https://mikescustomtoys.com/pages/smartcap

 

I had my smartcap installed by GTFOverland. I was in a hurry and left after install but the rear camera glass was just touching, causing a creaking noise. When I had time, I loosened the clamps and shifted it away by maybe a cm or two and now it’s good. I tried following the instructions to fasten the clamps to 9lbs per feet but my torque wrench isn’t clicking and keeps spinning. Picked up another and the same. Anyone have a picture? How far out is the bolt protruding? Flush? Dont feel like driving back to the shop and don’t feel like picking up a digital gauge.