Sequoia 2008

Cruise control won’t turn on. Changed fuse and the cruise switch with the wiring. Neither of these fixed the issue. What should I check next? Thanks

 

horn good ? how about radio switch ? might be the clock spring slowly going out.

 

Horn works. Radio controls on the left side of steering wheel don’t. Temp controls on the right side do work.

 

sounds like your clock spring is slowly going out. when the horn stops working, you know it's time to tear down the steering wheel
any noise turning the steering wheel ?

 

Thanks a lot for the info. I guess to get cruise I may just have to put that on my list.

No noise when I turn wheel that I have noticed.

 

Switch on the brake pedal, check that too.

 

If there was an issue with the brake pedal switch would it affect the brake lights as well as cruise?

 

Should be a separate kill switch that is behind the brake pedal.

 

Is your engine light on? Any other codes? As dumb as it sounds, try disconnecting the battery for a few seconds and reconnect.

 

No engine light on. I have disconnected the battery with no positive results

 

Shoot. Might have to scan it with a higher end scanner or techstream to see if there's anything helpful it can bring up. That's an odd one. Might have to do some continuity testing on the cruise switch wires from the switch to where ever they go to. To see if there a break or short in a wire.

 

It’s 100% your clock spring. Just had the same thing…no issues other than cruise control not working. Was the clock spring.

 

I am going to order one. Around 35 bucks so it can’t hurt. How difficult of a job is it to change that?

 

pretty easy, just be careful with air bag charge and the steering wheel orientation or else you end up with a crooked steering wheel plenty of YT videos.

 

Wanted to thank everyone for the information. Changed the clock spring and cruise and left side of steering wheel are working again.