1794 Driver's Seat - Need to confirm bottom cushion cover

Hi All,

I have a 2021 1794 and would like to replace the drivers side bottom cushion cover with the OEM cover. I've looked at the various online dealer websites for the heated & ventilated cover (in leather/suede) in the proper color but not sure if have seen the correct choice. The closest description for color has been 'Sand'. I don't think this is the correct description for the funky western grade color leather/suede used in the 1794. Can anyone confirm the correct part number?

Thanks in advance!

 

I don't think it's sand, in the 1794 editions, more of a saddle color, typically. Can you request typical photos of what they are calling "sand?"

 

I don't think it is sand either.
Call a dealer and give them your VIN; they can give you the correct part number.

I think this is what you are looking for, call a dealer and verify with your VIN.
If this is correct, your interior color code is E2

2018-2021 Toyota Tundra Cushion Cover 71072-0C503-E2 | Sparks Parts



Passenger seat.
2018-2021 Toyota Tundra Cushion Cover 71071-0C822-E2 | Sparks Parts




If you do purchase from Sparks: use the TUNDRAS.COM promo code for 5% off the subtotal.



That is better than their 25% off shipping.

 

Thanks a bunch! Not sure why brown did not show up when I was looking at all the color choices but that appears to be the correct part.

 

It wasn't showing up for me either.
The passenger and rear seats came up in that color.
I ended up taking the driver's black ventilated leather part # and replacing the E2 code on the end..
Then for some reason, it came up..

When you order make sure to include your VIN.
I could be wrong..

 

Good detective work! Yep, I used my VIN and it is a match.

 

What is involved with replacing the seat cushion for the driver's seat? My 2015 Tundra LTD needs that same cushion replaced? thanks

 

Remove the seat, take it apart and get yourself a 6 pack and some hog ring pliers. From there you just open up the hog rings pull the cover off the foam, stretch the replacement piece over it, and hog ring it back on. That’s about a 3 beer job. The other three for assembling the seat and putting back in the truck.

 

My truck only has 15k miles on it but the dude that owned it before me drug his wide load across the seat edge under full gravity. It's not bad (just creased) but the rest of the truck is too nice and I am too particular. I'll do the job myself - I'm not going to replace the foam but I was thinking of using spray adhesive and gluing down some 1/2 (or slightly thinner) good quality foam on the two bottom side bolsters to beef them up a bit and add more tush support. I prefer to not have to take it to an upholstery shop but if anyone has professional advise on how to make the best DYI of it while apart I am all ears!

 

Looking at replacing some foam as well as covers for my truck so I figured this would be a good place to ask. Sorry if it’s a thread jack.

first, is the seat frame and foam the same for different trims? Best I can tell it is but I figured I’d ask if anyone has personal experience.
Second, if the seats do interchange, can I put limited/1794/platinum seat covers on my SR5?

Am I just over thinking thinking this? Would it be easier to just swap in a whole seat from salvage or something aftermarket?

TIA