New member

Hello my name is Sandra I have had a 2007 Toyota Tundra that recently was totalled in an accident and I knew that truck inside out and backwards . The 2007 was a great truck no problems I always maintained my maintenance and in 15 years of owning the vehicle I only put on two sets of brakes and rotors and 3 sets of tires and1 O2 sensor. Now I am the owner of a 2014 Toyota crewmax and I am lost when it comes to even diagnosing this truck . Is there anything anyone can tell me to look for. I did recently have the problem with the blinking 4wheel hi and low and the ABS light on but it all went away when I changed out the ABS sensors it blew the code PO500. So I am just worried that I am overlooking something it was such an easy fix

 

Do you have your own diagnostics reader? I only have an Autel for my 2010 Tundra. Friend recommended it
for me. I'm not home so can't tell which one.
Open this same in the 2.5 Generation Forum. I'm sure someone there will be more informed than I am.

2.5 Gen Tundras (2014-2021) | Toyota Tundra Forum

 

Welcome from NY.

 

Thank you . Well does anyone know how to reset the abs . I changed the sensors and my lights are still blinking off and on with the abs light and now the 4hi and 4lo.

 

Welcome from LA (Lower Alabama)! Not everyone monitors the New Intros forum. You'll get a lot more (and better) response if you post your questions in the 2.5 Gen forum, or on the Ask the Toyota Mechanic thread:
https://www.tundras.com/threads/ask-the-toyota-mechanic.2404/

 

Have you disconnected the Neg battery cable yet? I know on some vehicles you could use a paperclip and jump 2 pins in the OBD port to clear codes/lights.

 

I replaced all four ABS sensors took the negative off for an entire afternoon . Reconnected the battery drove out of my driveway now the abs sensors back on my tractor control back on now my check engine light came on and my brake light is on as well as the 4hi and 4low. I can’t win. Any ideas

 

Same for me. Not sure where to go from here