Tire Size for Eibach Pro-Truck Lift 2 stage

Been looking and have not found the answer yet.
2016 Tundra Limited 4x4 with factory 20 inch rims.

Will a set of 285/60/20 tires fit with the factory rims with no mods other than the stage 2 lift?

 

I have that setup, you can fit 35 tall and 11-11.5 wide on factory +60 offset wheels with major fitment tweaks. Can keep mudflaps, need to trim skid unless you have the TRD skid. And remove from air flaps under front bumper.

I run 18 inch OR wheels, 285/75-18 tires which are 34.8 tall and 11.3 wide, so tires similar in size for your 20inch wheels will work. The size you are considering will be about 33.5 tall, 11.2 wide so should be fine.

 

Would I be better off going with a 275/60/20? Would any mods need to be done with this size?

 

You should be fine with the size you want. I ran 11 inch wide, 33 inch tall tires with no lift-275/70-18.

Stock trucks fit 34tall, 11 wide without lift. May need to remove those air flaps under the bumper.

You should look over the 2.5 gen forum.....thousands of pics and build info....many have done similar upgrades.

 

Would a 275/65/20 be to tall of a fit?
Looking at the Michelin ltx AT2 most driving is highway with some gravel road

 

Here is a tool for you to understand tire size, especially helpful with metric sizes

 

Thanks for the link to sizing.
So It looks if I can run a 33 inch tall tire

What did you have to do additional to run the 34 inch tall tire you used

 

re-read- I explained all that before.

Stock trucks fit 34tall, 11 wide without lift using stock +60 offset wheels

With 2 inch lift in front, 35 tall and up to 11.5 can fit.

If you are concerned, just run a tire in the 33-34 tall range and width of around 11 inches, those will fit stock or lifted with stock wheels.

 

Thank you for your advice and help. Much appreciated