Needle Bearing Delete Tools

I know there is a thread where someone is loaning out the tools it takes to do the needle bearing delete and install. I have sent messages trying to get on the list to use the tools with no success. Does anyone have these to loan out/rent out before I buy them and only use them one time?

 

Sorry, I missed your message, the tool is out in the wild. I don’t usually send it to anyone with zero posts, but stick around and join the community. We like pics, a lot

 

No worries, I figured it may have been because I was new and I don’t blame ya! I have a pile a parts waiting to be installed. I’m doing JBA UCAs, Fox 2.5s w/resis(should be here Monday from AccuTune), inner/outer toe rods, TC steering rack bushings, CV axles, sway bar end links, gussetted knuckles with new hubs and bearings(from Jim Simla). I just rebuilt my rear drive shaft, this week, with a new center support bearing and u-joints. Did lower ball joints(OEM), radiator/t-stat and hoses, and all fluids last year. T-belt and WP about 30k miles ago. Is there anything I’m missing or should be doing when I have the front end torn apart?

 

We don’t even know what you’re driving yet….

 

2006 DC 4x4. Sorry I’m active on the first gen tundra page and someone on there suggest to look here for the necessary tools so that is what I did.

 

From the looks of it, being the new guy on the page, I may have to buy a set. No big deal, I just didn’t want to spend the money if I didn’t have to. But what’s $200 when I’m $3-4k into the project

 

My price was including the seal and bushing, so yes you may be correct, sorry for the inaccurate statement

 

Hang out and get involved in the forum. There is a loaner tool making the rounds here for active members. I’m guessing that kind of thing doesn’t exist in FaceBook land. Oh, and we like pics, let’s see that beautiful truck! Welcome aboard hopefully

 

Nice looking truck. Digging the TRD wheels and the projectors.

 

Here is the thing I get asked the most about, Baja Designs Squadron Pros for fog lights with a custom 3D printed bezel.

 

The projectors are new, within the last two months. I need to find some time to get them properly adjusted.

 

Welcome Timmothy

 

The white pockets are pretty hot

 

Thank you sir! Trying to decide if I should go with the matching white ditch lights or not!

 

Don't be that guy!

It only takes about 10 minutes.
https://youtu.be/03fHzDEHVV4?si=-7wW91SIHAX_vsU-

 

They are projectors not LED bulbs in halogen housings! One is just higher than the other, I’m not blinding oncoming traffic!

 

Good looking rig! Later 1st gens are growing on me.

 

Thank you!