1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

No start after timing belt replacement

Discussion in '2nd Gen Tundras (2007-2013)' started by Antoine.r.321, Jul 3, 2024.

  1. Jul 3, 2024 at 3:18 PM
    #1
    Antoine.r.321

    Antoine.r.321 [OP] New Member

    Joined:
    Jul 3, 2024
    Member:
    #119358
    Messages:
    1
    Gender:
    Male
    Vehicle:
    2008 DC SR5 4.7L 4X4
    Just replaced the timing belt (and water pump, idler, tensioner) on my '08 4.7L 2UZ-FE. Everything came out fine, and seemed to go back in properly. Timing marks lined up, engine turned by hand no problem.
    After reinstalling everything and refilling the coolant, it won't start. Can turn the key to ON and try to start but nothing happens. Not getting any codes either. I'm able to start it by jumping the starter relay and it starts right up and runs. Tried to unplug and replug the camshaft, crankshaft sensors and all the connectors I had to pull to get to the belt. Any ideas what's causing the problem?
     

Products Discussed in

To Top