BAKFlip MX4 - extra bumper pieces?

Where do these go? Instructions do not say…

thanks for da hepp!

 

Not sure about the upper ones, but the lower ones look like they are the ones that go on the panel that rests up against the back of the cab.

 

Nope, they go at the cab end of the bed - they help keep the water out on the cab end of the bed...
for the larger foam blocks, Step 2.."Install foam block filler pad (F), with adhesive end up, as far forward as possible against the cab end bed wall/bulkhead."
for the smaller ones, Step 3..."Take the cab bumper (G) and remove the backing. Place it in the bulkhead valley as shown."

Look on page 2, steps 2 and 3 in the attached instructions.

 

Awesome! Thanks for da hepp!!! Definitely not in the way instructions from RealTruck. Just saying.

 

the instructions I provided are for an older version (12/2023) of the BakFlip MX4 from RealTruck...glad it helped