Have someone installed a OEM power step on a 3rd Gen Tundra?

Inspecting the wiring diagram, it shou ldn't be difficult to wire a a OEM controler to the main body ecu and build any additional harnesses needed for the steps and OEM switch.

 

Well, I've gather some parts for the cheap. I can easily do it per wiring diagrams, but if there's any successfull history to follow it'll be much better. Maybe I'll be the first.

 

thats funny right there. Well let er rip tater chip, make sure to take lots of good pictures and document the part numbers.....

 

Parts needed to build the harness, plus some pins That I have to include. The last doubt I have is if the Main body ECU is programmed to send and receive packages from and to the step controller.

 

Any one in the group is Familiar with LIN communication?

 

I am trying to figure out if the platinum trim comes pre-wired from factory with the harness that would connect to the Power Step ECM

 

It does not.