1st Gen. Lunch Table - General Discussion

EVO IV

 

You're such a dad

 

i thought the evo was a chick car. Maybe I’m confusing it with something else.

 

Bro...

 

https://youtu.be/CG7-Is8KFs8?si=MQmddq14uo2PW-xm

Education posted

 

Had a GF with a yaris. Even if it had 400hp, it'd still be a yaris. If those were c4 vette money, they''d get owned all over the road.

But its easy to respect a 1+hp/10cc turbo motor. Little bastrd will work so hard it wont survive puberty. But its got like 150lb.ft and doesnt do shit below 5krpm. But when it do be like it do, its a good time.

 

Thoughts on this Kia truck?

 

Unibody or bof?

 

https://youtu.be/nAmR1TjF190?feature=shared

Kia Tasman; I’m guessing unibody.

 

Honestly, I don't hate it.

 

Same. It looks pretty dope. I don't know anything else about it though.

I don't know of any other truck that comes with a winch from the factory. That's fuckin cool.

 

I'm sure the Kia Boys will figure out how to steal it real quick, and be using them for burglaries in no time flat.

 

Got dang USB Kia boiz

 

It's a Kia, so it'll look good as your engine disassembles it's self on the inside.

 

As long as it happens during the 7 year warranty.

I remember when most automakers gave a 10 year warranty. Now we're lucky to get 5.

 

It happens, when you sling a lot of seed.

 

Gross.

 

Ferd Edge Brakes Done (Rotors n Pads). Rear had issues. A seized slide pin I thought was going to break off, never ran into that before.
Rears also had twist pistons, new to me, not too bad with the napa tool. Pad shims/clips? were "skipped" on one side and the rear lugs were probably tightened to 150ftlb!
May have contributed to the warped rotor, but we've had this thing for a while since my mother quit driving (wouldn't buy one) and the pulsing just started. Spec is still 100 which seems excessive.
Happy purple grease where needed. I expended 2 large cans of brake clean Wooooo sniff sniff. Always bring one bucket of tools from my basement shop... and it grows to two after 5 trips up and down the stairs
New HF torque wrench
Break in tomorrow morning. I plan on looking up break in procedure because I always forget it, but any opinions on doing that?

 

This is insane. I never thought we'd see the Northern lights in Tennessee. We flew all the way to Finland to see them last year.

 

Lucky bastard. I’m in the field of view but too much light and toxic fume pollution don’t allow me to see.

 

We're right in the middle of the city and can still see them. Someone just posted this one from the area I go riding. If we had less light pollution here it would be crazy.

 

This is my view from Hopkinsville, I hate it (the light pollution)

 

Friends house

 

Put on the Pink Floyd

 

Hot ashes for trees, hot air for a cool breeze

 

Oh my. That is incredible.

 

I'm pretty jealous I'm stuck at work. Not that we could see it down here on the dirty 3rd.

 

Interesting. My phone camera can capture it but I can’t see it.

 

Samesies