StartX remote starter for 2024 Tundra - LTA & cruise malfunction

hey, i just installed the remote starter and it works great except LTA and cruise control shows up malfunction. any idea what's causing the issues?

thanks.

 

welcome to the forum

first, nobody is going to be able to help you or diagnose anything when you have 0 details in your post.

what truck do you have
what remote start did you install
who did the install
have you tried just pulling the neg bat terminal and see if a reset cures

 

Thanks for the tip.
It’s 2024 Tundra SR5, StartX remote, I did the installation and reset, reprogrammed didn’t work.
Thx.

 

Contact the manufacture

 

i did. waiting on them but meanwhile wanted to see if anyone had a similar issue.

 

just curious but is the factory fob and then phone remote start not good enough ?

 

I have one of these as well and occasionally I get a bunch of errors on the dash when I use it. It doesn't happen every time, but quite often I get the errors. These are parking sensor, adaptive cruise errors. It is actually an issue with the radio rebooting when it switches over from the Start-X to the normal system. I have caused these errors by holding in the radio volume adjust until the radio reboots, without having the Start-X even installed in the truck. I was having Android Auto issues so I rebooted the radio to resolve them and caused the errors. For me they go away right away, except maybe 1 in 10 errors the parking sensors stay faulted until I shut the truck off and turn it back on.

 

Not to be a nudge but here goes...I cringe when I see aftermarket remote starts on any vehicle...tampering with the electrical system on a modern vehicle, especially a newer one with all kinds of sensors and integrated systems is just asking for trouble. Everything is voltage and load sensitive resulting in glitches and ghosts that warranty won't cover. You added one on top of the factory that already wasn't working correctly. IMHO remove all traces of it, reset your factory setup, and hope the dealer can/will fix the factory glitches with an update or find a defective part under warranty.

 

disconnect / reconnect the battery should fix that.

 

Did you ever figure this out? Did you have to flash the module on your computer?