2011 Tundra 5.7L SR5 - Crank no start

I have 2011 Toyota Tundra SR5 4 door.

Ran fine no trouble, then ....

Crank No Start problem, fires up for a second then shuts down, then just crank again no fire at all, turns off, and restart fire up for second then shuts down.
Check all the fuses, fine, unpluged the Map sensor, still no start, changed the fuel pump relays, still no start, put more gas into the tank, still no start.
Reset the ECU, still no start. Hit the gas tank with rubber mallet, still no start.

Fuel filter is inside the gas tank on this model.

I'm no sure what it is , bad fuel pump, clogged fuel filter, ????

I need help.

 

Any codes at all involved with this? May be easier if someone else puts the key in the ignition and turns to on position (not fully trying to start) to hear if the fuel pump is turning. If you hear silence it may be the fuel pump.

 

I did not hear the fuel pump starting. I was right next the the gas tank to listen for it.

Codes that I got was P102 Mass or Volume Air Flow Circuit Low Input, P0113 Intake Air Temperature Circuit High Input, and P2757 Torque Converter Cluth Pressure Contol Solenoid Control Circuit Performance or stuck off.

 

Research fuel pump control module

 

Fuel Pump Control Module. Location is inside frame above rear driver side tire. My truck is literally in the shop right now for this as I type this. Same symptoms as yours. Depending on the engine and trim etc., your fuel pump ECU part number varies. Mine was 89570-34010

Can find them on eBay but I highly recommend new from dealer. I tried installing used module myself and wires ended up corroding on me. So I took it to the shop and picking it up later today.