2015 trundra w/o jbl

Hi everyone so I recently purchased a new HU DMX7709s and a datalink RR, HR TO2

what I am trying to accomplished is to run all my Speakers, to my 4ch amp and my subs to my 2 ch amp I’m a little bit confused and frustrated cuz I did that but still have no sounds just bass. I run the wires from the dash to the amp idk if that’s right or do I need to run the wires from were the old factory amp used to be thank you

 

So you removed the factory head unit, and factory amplifier (under passenger front seat)?
If thats the case, then you should be running rca cables from the new head unit to the amplifiers, then you need to run speaker wire from your 4ch amp to under the front passenger seat and connect them to the factory wires that go to the door speakers.
Just fyi, i'm not 100% sure on a 2015, but i believe the factory tweeters are powered by the factory head unit, so if you are planning on re-using the factory speakers you'll need to figure that out.....i'd just replace all the speakers.

 

Ok cool do you happen to know the speaker wire colors

 

Welcome from NY.

 

Welcome from LA (Lower Alabama)!

 

Not off the top of my head, but look in the AV section and i think there's a thread pinned that has them listed.