Transmission fill question

Hi all. Dumb question. I have a 2007 tundra 2wd. I was performing a drain and fill on the transmission. I didn’t see a 24 to fill it. I did however see a t55 bolt that goes vertically. Can I fill through this plugs as well?

 

These are my notes from my first transmission drain and fill.
"Loosen all three bolts (1 is drain bolt, 1 is check bolt, one is up high on the side 24mm and has "WS" on it). This way you know you can get them out when needed." I have 2WD also and it wasn't too bad to get to it.

 

I’ll check again. Maybe I’m blind!

 

I don't have an 07, so apologies if this is incorrect.

The 24mm will be up high (above the catalytic converter). It'll be easiest to reach from under the driver's door/behind the front wheel. It'll look difficult to reach, but all the tools fit without issue.

 

I found it. I’m blind!

 

Welcome to the forum!

 

Thank you