Turn signal and hazards

Hello , my turn signals and hazards stopped working help , I already replaced the fuse under the hood , the fuses under the drivers side is missing the cover so idk what fuse is what or if I need to replace one there too ? Does anyone know were I can order a replacement cover ?

 

Not sure where to send you, but covers are readily available from Amazon or Toyota. Here's a link to your fuse block that might help you out. Check the #15 7.5 amp fuse located here.

https://imgvehicle.com/toyota/tundra-ii/fuse-box

 

Thank u , will do i appreciate it

 

Welcome to the forum from OKC!
If fuses aren't the problem, check out your wiring and cabin air filter for rodent damage or evidence. If not already done, screen the HVAC fresh intakes under the windshield wiper cowling.Mice like to get inside these trucks and do lots of damage sometimes. Best to prevent it before it starts. Under the hood I have had success with pine sol soaked rags and bars of pink Dove soap wedged into random pockets around the perimeter of the engine compartment.

 

Thank u !

 

Welcome to the forum.

Any chance you recently replaced a bulb?
The front turn and DRL bulbs are a bit particular about having the correct bulb.
The 921 rears not so much.



With all your lift and stuff, there are a few members that have found wiring pinched or crushed under the truck.
Did you check and see if the front and rear sockets had a good ground?

Info below shows what wire is what in your sockets..

Good luck


Ultimate TUNDRA Wiring Diagrams Collection | Toyota Tundra Forum (tundras.com)



Front





Rear

 

Welcome from NY.

 

Welcome from LA (Lower Alabama)!

 

Welcome from the Great State of Texas!

 

Welcome from Nevada