1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Anyone ever lose power at the OBD port? ScanGauge 3 shut off

Discussion in 'Electrical' started by Tundra234, Nov 5, 2023.

  1. Nov 5, 2023 at 5:09 PM
    #1
    Tundra234

    Tundra234 [OP] New Member

    Joined:
    Nov 30, 2018
    Member:
    #22402
    Messages:
    18,015
    Gender:
    Male
    First Name:
    George
    Florida
    Vehicle:
    2020 Tundra DC SR5 Barcelona
    Alot of them
    Anyone ever have a glitch where they lost power at the OBD port? I was driving and happened to glance down and saw that my ScanGauge 3 was powered off. It was a short drive so I didn't notice if it shut off during the drive or didn't power up when I started the truck. I unplugged it and plugged it back in and it powered up. This is weird because about a week and a half ago I had one of my TPMS sensors kick the light on and said it was at 13 psi. After I restarted the truck it was operating normally again.

    Edit.....now that I'm thinking about it, the SG3 is plugged into a splitter because it shares the port with my Pedal Monster. The truck drove normally based on sensitivity setting in the PM, so the OBD port would not have lost power or I would have felt the stock acceleration response.
     
    Last edited: Nov 5, 2023

Products Discussed in

To Top