1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

HVAC gear missing teeth

Discussion in '1st Gen Tundras (2000-2006)' started by Dracko, Sep 22, 2023.

  1. Sep 22, 2023 at 8:01 AM
    #1
    Dracko

    Dracko [OP] New Member

    Joined:
    Dec 18, 2022
    Member:
    #88803
    Messages:
    88
    Gender:
    Male
    Vehicle:
    2005 Tundra SR5
    Am I the only person hamfisted enough to shear teeth off this heater control knob gear? Wondering if this is a common enough problem that these are being 3d printed or if there is a way to only buy the gear and not an entire control cluster ? I greased up the cables and diverters but the damage has already been done….Any advice appreciated. I attached a couple pictures of what I’m talking about, it’s the one that controls airflow direction.

    IMG_4991.jpg
    IMG_4992.jpg
     

Products Discussed in

To Top