1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Hello everyone, been a long time since I have been here

Discussion in '1st Gen Builds (2000-2006)' started by jmohn6, Jul 25, 2023.

  1. Jul 25, 2023 at 2:21 PM
    #1
    jmohn6

    jmohn6 [OP] New Member

    Joined:
    May 7, 2021
    Member:
    #62746
    Messages:
    21
    Gender:
    Male
    But I do a little help, I'm pulling the engine out and so far going ok, but the connector off the main harness that pig tails to the transmission and rear sensors, i'm having a hell of a time undoing the connector not enough room from the rear of the engine. So I'm wondering if anyone else had the same problem and what they're solution was.

    2004 Toyota wiring harness number.jpg
     

Products Discussed in

To Top