1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2007 Tundra Brake short

Discussion in '2nd Gen Tundras (2007-2013)' started by Jablippy, Jun 8, 2023.

  1. Jun 8, 2023 at 8:50 AM
    #1
    Jablippy

    Jablippy [OP] New Member

    Joined:
    Jun 8, 2023
    Member:
    #98291
    Messages:
    1
    Gender:
    Male
    Vehicle:
    2007 Tundra 5.7L
    My 2007 has a short somewhere in the Stop wire circuit. The STOP fuse blows almost immediately when the brake is applied. Checked all of the obvious things with no luck. Funny thing is, the starter fires up for a split second when I apply the brake before the fuse blows. I'm stumped at this point, and any suggestions would be greatly appreciated.
     
  2. Jun 8, 2023 at 8:59 AM
    #2
    blackdemon_tt

    blackdemon_tt Battery Slayer

    Joined:
    Feb 27, 2020
    Member:
    #43241
    Messages:
    3,050
    Gender:
    Male
    Vehicle:
    2007 5.7l Tundra DC SR5 long bed 2wd
    TRD Sway Bar, Roll covers USA bed cover
    Check your ground points. Kick panel driver side would be my first check. Make sure the grounds there are good. 2nd one may be rodent dropping or damage to your wiring someway somehow.
     

Products Discussed in

To Top