Wiring Sequential LED driving light/turn signal

I got a question about the wiring on the sequential turn signals. First off, when we first installed them on my 2013 Toyota Tundra and turned my headlights on...they just steadily ran like the hazards were on. So, I wired in some load resistors and stopped that issue, but now if it's daytime and I just turn on my parking lights they do the exact same thing! They work fine with the headlights on now though!? Any idea what could be causing this? I'm lost as to why it fixed one issue and created another.

BTW...I have regular turn signal bulbs plugged into the turn signal socket....not LED!

 

This sounds like information you should find in the installation instructions as it's part of setup and programming.

Can these be programmed by doing combinations of inputs like turn indicator and/or hazards on to change settings?