1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2008 Tundra - P0335 & P0339 Fault Codes

Discussion in 'Performance and Tuning' started by 4245FTHD, Jul 9, 2022.

  1. Jul 9, 2022 at 7:54 PM
    #1
    4245FTHD

    4245FTHD [OP] New Member

    Joined:
    Aug 12, 2020
    Member:
    #50697
    Messages:
    5
    Gender:
    Male
    Vehicle:
    08/14 Tundras
    I need help!!!! I have a 2008 Toyota Tundra SR5 4WD 5.7 Litre 3UR-FE


    The truck bucks and stalls with Fault Codes P0335 & P0339 Crankshaft Position Sensor "A" Circuit and Crankshaft Position Sensor "A" Circuit Intermittent. I have replaced the Crank Sensor twice with a Toyota Sensor. The customer brought me a Re-flashed ECM he got from a company on the Internet that specializes in Engine Computers. You send them your VIN and they program it for you. I haven't done a Crank relearn because my Snap-on Triton Scan Tool does not have this function. The truck was fine for awhile now the problem has returned with a vengeance. I have scoped the Crank sensor pattern, and the V-Ref signal. The crank signal goes away as the engine stalls and the Fault Codes return. V-Ref remains steady. It is like the signal is not being pulled to Ground. I have attached A picture to this Thread. I have checked the signal at the sensor and at the ECM. I have done a major harness wiggle test, and I have checked the connectors for corrosion. The only thing I haven't done is strip the harness down and pull the trans to check the Trigger plate, but the signal doesn't give me any indication there is something wrong with the Trigger plate. The truck does not qualify for the updated harness from TSB-0220-08 due to water intrusion. I checked the connectors anyway. Sometimes the truck will just stall while idling in park. I feel heat has something to do with this but what???? Sure Track from Snap-on shows Techs have replace one ECM and One Camshaft Sensor, then a whole lot of Crank sensors. I have not seen anything that would suggest the Camshaft Sensor is faulty, nor the VVT sensors. They are all feed by the same V-Ref signal. Powers and Grounds check Ok. I have to be losing/missing something???
    I have attached a picture of the Crank Sensor Wave form when the Truck is about to stall.

    Any thoughts/ideas would be greatly appreciated.


    Greg

    upload_2022-7-9_20-53-40.jpg
     

Products Discussed in

To Top