1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

In-Cab High Beam Source/Signal

Discussion in 'Lighting' started by YouFallWeHaul, Dec 28, 2021.

  1. Dec 28, 2021 at 6:29 PM
    #1
    YouFallWeHaul

    YouFallWeHaul [OP] New Member

    Joined:
    Dec 28, 2021
    Member:
    #72360
    Messages:
    35
    Gender:
    Male
    Vehicle:
    2010 Marine Blue DC 4x4
    Hi - new guy here. I've had a 2010 DC for about a year now and have been steadily doing a few mods here and there, including electronics (CarPlay HU with front and rear cams) and I am now focused on lighting. I have two 6" Diode Dynamics LED bars with some custom fabbed brackets that sit behind the grille (I can post some pics in the morning) and the DD wiring harness/relay.

    I would like to tap into the high beams so they come on together, but I would prefer to do it near the switch, in the cab, rather than tapping into the actual high beam wire at the lamp.

    Anyone found a high beam signal wire that is under the dash or drivers kick panel? I've looked at a bunch of wiring diagrams (from this site, and Haynes) and honestly I cant figure out where to look. Thanks in advance.
     

Products Discussed in

To Top