1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Wiring for component speakers

Discussion in 'Audio & Video' started by Do58, Sep 10, 2021.

  1. Sep 10, 2021 at 1:23 PM
    #1
    Do58

    Do58 [OP] New Member

    Joined:
    May 9, 2020
    Member:
    #46334
    Messages:
    299
    Gender:
    Male
    Hello, about to install my kenwood component speakers. 6x9 in the front door and 2.5 in the corners of the front dash. Question is….
    Is the factory amp under the passenger seat powering the corner dash speakers or is the radio? I’m not sure if I can just install the inline crossover using the wiring at the dash or if I need to run a wire and tap the 2.5 with the crossover down to the kick panel and tap the 6x9. Seems easier if I can just use the wiring in the dash as long as I use the inline crossover to save the 2.5 speaker from blowing.
    TIA
     
  2. Sep 17, 2021 at 4:34 PM
    #2
    FirstTruck

    FirstTruck New Member

    Joined:
    Sep 30, 2018
    Member:
    #20013
    Messages:
    416
    Gender:
    Male
    Vehicle:
    18 Tundra MGM CM TRD Sport
    Stock, for now
  3. Sep 17, 2021 at 4:37 PM
    #3
    FirstTruck

    FirstTruck New Member

    Joined:
    Sep 30, 2018
    Member:
    #20013
    Messages:
    416
    Gender:
    Male
    Vehicle:
    18 Tundra MGM CM TRD Sport
    Stock, for now
    Install the crossovers under the passenger seat and run a new wire to the dash
     

Products Discussed in

To Top