Fitment Question

Could anyone shed some light on the fitment on a 2011 Crewmax 4wd at stock height with the following setup?
I have a BDS lift kit on order but it is very delayed with no end in sight. I am planning to have the tires and wheels, which I have in hand, installed now but was not sure about rubbing.

Any help is appreciated.

Fuel Shok Matte Bronze 18x9 1mm offset
Nitto Terra Grappler G2 LT285/65R18

 

It will most likely rub. That's a descent size tire.

 

RUB, front wheels, forward and reverse, front flaps and rear flaps, possible body rub too.

 

Thanks, the flaps I wasn't too worried about it was more the body.

 

You'll never know until you get them on.

It's just my opinion, but I think you'll be rubbing all over the place

 

Issue is the high offset of your rim choice. 285/70-18s will fit on stock +60 wheels on a stock suspension truck.

I run 275/70s- taller and slightly thinner than 285/65, with stock wheels and suspension and have no rubbing or issues. Now if I used rims at 0 or +1 like you listed, no way the tires would fit and they would likely rub front spats, plastic wheel well, mudflaps, maybe body mount.

 

OK thanks, I needed that at least that offset for the lift kit that is coming. I guess I will just wait for all the pieces.

 

Since you have lift on order test fit if rubs like crazy just put back on stock set up.