3D Printing

Can you increase the resolutionin printer settings?
Opps. Didn t notice that post is a few years old

 

I lied to myself
I bought a Prusa MK3s kit and then bought one assembled. The assembled one was supposed to be donated to the school where my sister's kids are. The school had amibitions of starting a small STEM lab. Then COVID hit. So I'm putting hours on both and mainly taking designs I like and printing them. At some point I'll muster up the courage to figure out the CAD stuff.

 

I've got an Ultimaker S3 at work...so I get to be a little spoiled. Less tinkering and more just "load and print." That's not to say I've royally screwed some prints up, but it's been more rare than some of the horror stories I see when reading about other people's experiences.

 

I 3D printed a forend for my Winchester 1300. I used carbon fiber infused PETG.

 

Following this. Just got an Ender 3 this past month and have been toying with it. Thingiverse has a couple Tundra related files.

 

When I installed sliders on my truck, the brake lines rested on the back plates of the sliders. I was concerned that eventually the rubbing could damage the lines. I 3D printed some spacers to raise them off the plates. Worked out nicely.

 

These look nice... I may jump on this to reproduce some discontinued parts... 1 of my cars need a few parts...