AT/temp light / 4 LO blinking / Traction Control help

Ok I've searched through all the comments and I'm still clueless on what's the fix for my Tundra.
I have a 2010 crewmax 4x4 with 5.7. I just bought this truck with 265k for my shop truck and have only put six miles on it.
I've had the 4 LO flashing light come on and traction control when just Ideling in the garage in park.
Also had the at temp light come on after short yard drive and the engine just stalls.
Afterwards I drained 4-1/2 quarts from the trans, didn't pull pan and it wasn't too bad and smelt ok and replaced fluid and still had both lights again.
So what's the problem and how do I fix it?
Thanks

 

Codes. You need to know what codes are active. Then you can begin troubleshooting.

 

I ran a OBD scan and it showed I had a bad MAF, put one in and cleared the codes.
I'll let you know if anything pops back up.

 

Codes that I had before replacing the Mass Air Sensor, p102, p0113, c1201.
It's been a week without any new warning lights after clearing all the codes.