Bad vibrations

I am getting steering wheel shake almost a thumping at different speeds different intensity sometimes 3 times a day maybe not for another week or month. it starts and gets worse as I slow down.i stop start back up it’s gone.this is the only consistent part .once 4 months ago on exit ramp I thought a tow home was coming violent shaking - pulled over then started up to get to safer place, it was totally gone didn’t happen again for a couple weeks ! It’s a 2013 rock warrior never been damaged 75000 mi. Any help out there?

 

Mine started a few months ago. Sometimes around 35-65mph then smooths out, other times all mph ranges for a few minutes. I have had it on and off with stock rims, aftermarket rims. Stock tires on aftermarket rims and new tires on aftermarket rims. Before the 3/1 level kit and after. Gonna get under this weekend and check any wear out parts. Got 52K on the clock right now.

 

You guys ever figure out what it is ? I have the same problem

 

Been having the same problems

I have changed Tires
Rear Axle’s
Break rotors polishes
Brake pads to EBC
Upper control arm bushes (Total Chaos)
Removed spacers
Re-connected sway bar
Replaced. Steering rods
Rebuilt steering rack

Nothing seems to be solving the problem.


But still bad vibrations on high speeds

any other suggestions apart from buying a new Truck ? ✌

 

I have replaced almost every part of the front end. The only remaining items are the upper and lower ball joints and the wheel bearings. I will let you know if any of these fix the issue.

 

Check your lower A arm bushings that go to the frame , and wheel bearings . Is what the book recommends.. iv been researching this too and seems the lower A arm bushings are 90% of the culprits

 

Driveshaft

 

Damaged aka warped rotors will shake too even without touching the brake pedal.

 

Update - I have done the Rotors - Brakes - Lower control arm bushings --> No CHANGE

I put back the stock rims and tires and it got better. I then replaced the rear shock with 5100's and the problem is 90% gone.

I am going to the junkyard tomorrow to pick up a drive shaft. I will use new ball joints in case one of them is prematurely failing.

I will update you after the weekend.