Not tundra related

Looking for some help from my fellow ocd brothers and sisters. I cut a hole in my phone case for my magnet mount plate. I am now trying to find a trim of some sort to go around the inside of the cutout to make it look finished and hide some of the rough cut. Any ideas of what to use? I have tried door moulding but it is too thick. I tried gorilla tape but it won’t stick and I can’t get a good uniform cut. I think some type of thin u molding would be best but I can’t find any small enough.

 

Vinyl strip?

 

Im thinking something along those lines. I just don’t know which one. Like cut a strip off a roll you think?

 

I’d try some pinstriping since it’ll be uniform in width.

 

Yes sir

 

I’ll give that a whirl

 

I didn’t even think of vinyl or pin striping. I’ll definitely try those.

 

Try weed eater fuel line...yellow or black.

 

Throw a slice down the middle and glue?

 

no just cut it lengthwise at stick it around edge

 

the hose is really tiny, just cut it with a razor blade(mind fingers) and you should be good to go

 

Thank you sir. I have a 5 pack of vinyl and a weed eater gas line in the shopping cart

 

no problem