1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Actuator step by step

Discussion in '2nd Gen Tundras (2007-2013)' started by PBROWN2277, Jul 30, 2019.

  1. Jul 30, 2019 at 4:36 PM
    #1
    PBROWN2277

    PBROWN2277 [OP] New Member

    Joined:
    Jul 30, 2019
    Member:
    #33911
    Messages:
    1
    Gender:
    Male
    Vehicle:
    08 CREWMAX 4X4 TUNDRA 5.7
    NONE
    08 tundra crewmax 4x4 5.7 L
    Hi
    I have looked for hours, and this seems to be a much related issue. I am at fault, for not marking everything (like I normally would do) , but I made the Youtube mistake of getting started on something that seems easy, and probably is without marking things before removing the plastic housing of the 4 hi and 4 low plastic actuator housing from the transfer case, and before reinstalling it want to make sure I only do it once. I would greatly appreciate info if there is someone who can help. I need to know where to set my gear selection as to park/neurtral/drive / etc. 2nd thing is exact location of little gears inside plastic actuator housing of both the 4 hi and lo sides inside the plastic housing., and lastly where to push in or pull out the actual rods coming out of transfer case before reinstalling the plastic actuator housing back onto transfer case. again any help would be greatly appreciated since I have my truck on my lift, and ready to reinstall so I can use truck without any issues or damage. At this point I would be glad to jjust have my 2wd so I can return the rental truck I got. Thanks
     

Products Discussed in

To Top