1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Starter Issues with 02 Tundra

Discussion in 'General Tundra Discussion' started by northof50th, Feb 13, 2019.

  1. Feb 13, 2019 at 2:50 PM
    #1
    northof50th

    northof50th [OP] New Member

    Joined:
    Feb 13, 2019
    Member:
    #26032
    Messages:
    3
    Gender:
    Male
    First Name:
    Tyler
    Vehicle:
    2002 Tundra
    Brute Force Fab front bumper, fenders rebuild and bedlined, rear air bags, built in compressor
    Hello All. New here.

    So I recently had issues with my starter not engaging or disengaging when its cold out. So I replaced the starter.
    IMG-1688.jpg
    Took me all day to pull the intake manifold out and replace the starter, but even with the new starter it still grinds a little after it starts. It fires up, I let off the key and it grinds for a good three seconds ish.
    Anyone have any idea what this might be? The old starter wasn't horribly worn, so I sure hope its not the flywheel.
    Thanks!
     
  2. Feb 13, 2019 at 2:59 PM
    #2
    Jerry311SD

    Jerry311SD New Member

    Joined:
    May 3, 2018
    Member:
    #14997
    Messages:
    801
    Gender:
    Male
    First Name:
    Jerry
    Ramona San Diego CA
    Vehicle:
    05 Tundra
    Starter
    Relay
     

Products Discussed in

To Top