What have you done to your 1st gen Tundra today?

Saw those last night and ‘for the price’ they are good. They are 1000 lumens which is what the new halogens just installed put out. Looking for something better.

 

2%? Can you even see out of that?

 

Added a Swing Case on the drivers side:

 

I don't see how. I have 5% on my front windows and it's too dark. I have to roll them down at night when parking.

 

Yellow bulbs. That's what I did

 

Lol yeah

 

Sunny California, we pay more for enough sunshine to see through dark tint.

 

Non yellow for me as well.

 

Good question. I think the new ones from Napa are 8mm. I believe OEM are 10mm but I can’t remember for sure.

 

Sounds right. My 10mm wrench didnt fit on my new bleeders so I used an adjustable carefully. I just hope they dont get snapped off or something.

 

Yeah wouldn’t hurt to have a spare valve. I’m guessing the OEMs May be too large. Might have to grab some 8mm ones if they are

 

wait so you're gonna put another 2% tint over the 2% tint that's already there?

 

5-0 would be like white on rice ‘round here.

 

Those swing cases are sweet! I want to get some of those eventually. Difficult to put in?

 

Extremely easy, takes about 5 mins. It’s not a direct fit since they’re for the 2nd gen tundra but they’re solid.

 

Just bought all new parts and upgraded SS brake lines for the Tundra. Did EBC stage 3 fronts and Centric rears.

 

Do they require drilling or use existing screws?

 

Sylvania Silverstar Ultra 9003

This is the beam cut off at low beam setting from 25 feet back. Nice, clean, and level. A far superior improvement over the old scattered light China bulbs which had no cut off line at all!

 

6 self tappers per case.

 

It's not as dark as you would think. I can see fine.

 

That's some mighty good tint. Where'd you get it from?

 

Went to my local u pull junkyard and got a tailgate from a 2006 Darrel waltrip edition. It was the only double cab tundra I’ve seen in the junkyard.

 

Rare birds.

 

It still has the original BBS wheels! Those are worth some $$$! Are all 4 still there?
That's a limited edition grille too.

 

Some of the interior was stripped out but most everything else is intact. It even has a full Trd exhaust.

 

Nice! You oughta buy the whole thing!


Jk!

 

Expensive? I’ve dented my rear passenger door pretty good thanks to some mud and a tree... wonder what they’d charge for that? I’m not too far from ya

 

I think it’s around $75 for a complete door. It’s at pick and pull in Springfield MO and they have all there prices listed on there website.

 

Finally found this post you mentioned. Did you mention that the only thing holding these down is double sided tape? How bad did it look under them?

 

Each strip is held down with a few pieces of tape. There was some dirt under the strips but not bad. No rust.