RBP Repulsor

There may already be a thread on this, but I am sharing my experience so far.

I recently purchased (and had mounted) RBP Repulsor 33’s on my Tundra. Last four sets I had were:
1) Nitto Trail Grapplers
2) Nitto Terra Grapplers G2
3) Nitto Terra Grapplers
4) Toyo Open Country

***these were NOT all on my current truck, but all were on Tundras (07’ 15’ 18’)

So far I am impressed. The cost alone was a huge savings. They were shipped to my door for $918.00. That was a crazy savings compared to any of the other brands.
They mounted and balanced fine. I have no shakes at any speed up to 80 on the interstate.
What surprised me was the lack of the drone I have compared with the Nittos and Toyos. The cab noise is nonexistent when driving under normal conditions.

Obviously I can not give a report on tread life (as I only have 300 miles on them), but so far so good

 

I'm going to have to check these put!!! Wonder what the A/T's look like

 

Ordered these in 35x12.5r18 2 days ago and I'm pretty stoked. Thanks for the info. I'll post here an update also.

 

made in china ?

 

Yes. They are made in China

 

Crazy stoked about these. They are some awesome looking rubbers

 

looking good

 

Transformation in progress. Hope to update pics tomorrow. Had a lot of rain today and yesterday so in typical Dan fashion, my update will be testing out the 9 inch lift and rbps

 

They look good and agressive. I’m a fan if they are quieter too that’s such a bonus.

 

Going from a level to 9 inches was just nasty. RBP just got their first dose of mud and man did they perform. Virtually no road hum or drifting. Happy so far and will put these bad boys to the test and keep updating for y'all who want to save a buck or 2 and not give up performance.

 

Looks good bud!

 

Nice headlights

 

you got plenty of space to play where you at @AnonVet
I'm always riding around Jawbone.

 

Whaaaaa. I live in Cal City and putt around just where ever

 

I need to figure out how to adjust them. The cut off is above everyone's vehicles lol

 

What’s wrong with your motors?

 

They're waiting for you to come swap them off the stock heads and install them lmao.

I'm an engineer and don't wanna try that project. Heard spyders were a pain in the ass to hook motors up on.

 

Incorrect
Just watch the YouTube video

I’m retarded and did it in 30 minutes

 

YA ALMA... why you holding all this knowledge lmao

 

That was a stone cold offer for free beer, wheeling, and smoked bbq... don't you ever turn that down sir

 

That “free beer” would cost me $800 in gas

 

https://m.youtube.com/

YouTube is fairly simple to find. Not Quite sure why you needed it

 

What of the BBQ is just that damn badass lmao. Might even take ya on a date to edwards afb and see some jets lmao

 

Uhhhhhhh I need what goes after the / lmao

 

A British dude just showed me how to do it on a land cruiser in 1 minute and 30 seconds and I call BS lol

 

Me too! Hang tight. I’m looking for it