1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Transmission replacement help!

Discussion in 'General Tundra Discussion' started by Jabraco, Nov 23, 2015.

  1. Nov 23, 2015 at 3:09 PM
    #1
    Jabraco

    Jabraco [OP] New Member

    Joined:
    Jun 10, 2015
    Member:
    #1401
    Messages:
    8
    Gender:
    Male
    Vehicle:
    2001 Tundra V6
    Never done this before, learning as I go and trying to figure it out. I have the replacement transmission back in and the bell housing bolted to the engine. I made sure the TC was seated all the way back on the input shaft. My problem now is trying to line up the holes to bolt the torque converter to the flex plate. I am trying to rotate the plate by prying in between the teeth of the plate but the torque converter is rotating at the same time not allowing me to align the bolt holes. Any suggestions?
     
  2. Dec 1, 2015 at 6:50 AM
    #2
    Jabraco

    Jabraco [OP] New Member

    Joined:
    Jun 10, 2015
    Member:
    #1401
    Messages:
    8
    Gender:
    Male
    Vehicle:
    2001 Tundra V6
     
  3. Dec 1, 2015 at 1:33 PM
    #3
    T-Rex266

    T-Rex266 Elon approved Staff Member

    Joined:
    Jan 5, 2014
    Member:
    #6
    Messages:
    156,362
    Gender:
    Male
    Post your question in the "ask a Toyota mechanic" thread, OP.
     

Products Discussed in

To Top