Trim for a removed grab handle

I want to remove the drivers grab handle on my 2013 I recently obtained because it is in my periphery and my OCD will not leave it alone. Are there after market trim tabs that will replace where it use to bolt into? Or will I need to replace the whole pillar trip piece?

Thank you

 

Replace the whole pillar trim.

 

First time I ever herd of someone wanting to remove the handle.
I would think you would be able to find someone to swap pieces otherwise the trim pieces are available thru dealer

 

Indeed so.

 

https://www.ebay.com/itm/1771367441...MI2tnowfHhjQMVEVN_AB3hQTKMEAQYASABEgLZNfD_BwE

https://parts.toyotaofgreensburg.co...MI2tnowfHhjQMVEVN_AB3hQTKMEAQYBCABEgL3iPD_BwE

 

Where are you located? Tons of us probably have the piece you are looking for after we removed just to add the driver side grab handle.

Or stick around the forum to meet BST requirements, and then post up a trade. Guaranteed someone would trade their non handled piece for your handled piece. It's an easy swap too.

 

I am in Northern Virginia by DC

 

It is hard to see on the schematic, but does the part # 62210-0C050-B0 come without the holes for the handle? I see the 62210-0C060-B0 is just a clean section of molding, however, it says it does not fit (starts at 2014).