Hard folding bed covers that allow use of bed rails

It is difficult to tell from spec sheets and online info which hard folding bed covers allow you to retain and use the bed rails. Please post here if you know which ones do.

bakflip mx4?

toyota’s branded accessory bakflip?

Weathertech hard folding cover?

what about the hard style roll up cover?

 

I have the BakFlip MX4 and it does allow for the use of the bed rails, however I think there was a recent "update" that may have hindered that. I could be wrong though.

 

I have this one and can still use the tie down rails. Clamps for the cover do use the rail system so there are points on the rail you can't use.

https://www.agricover.com/lomax/

 

I have the OEM Toyota tri-fold and it allows the use of the bed rails.

 

I have the MX4, but had to use smaller tie-downs I found on Amazon - the stock cleats were too big.

 

Big fan of my retrax xr pro versus the backflip it replaced.

 

does it allow the use of the bed rail system?

 

Sure does

 

Hard cover? That's a diamondback switchback. Rails are available under the folding sections.

 

I have the LoMax hardcover and I can still use the rails AND tiedowns

 

I got a motorsports AL3 it fits with the rails intact.

 

OP
The Agri and WeatherTech are the same cover just different branding
I have the weathertech. Been a good cover, starting to leak if water sits on cover at certain angles in driveway. Would purchase again, had for 3 years

 

Agricover / Access - LOMAX Hard folding tonno cover

- Very low profile, strong, light weight, single layer of heavy gauge aluminum. (vs thin panels over styrofoam).
This eliminates the possibility of the cover absorbing water and becoming waterlogged and heavy (like some popular brands).
- Seal / gasket is on the underside, pinched between the cover and bed rail, not stuck on top where it is exposed to UV rays.
The hidden compressed gasket not only looks better than seeing rubber around the entire perimeter of the cover,
it also provides a better seal, and it is much less likely to shrink or peel off since it is being pinched in place.
- Durable Urethane / Spray liner style finish.
- Easy to install. No drilling. No drain tubes. Easy to remove in seconds without tools.

 

I have an Undercover Flex, works with existing factory bed rails.