Milwaukee Tools

I have not had great luck with Milwaukee bits

 

https://www.homedepot.com/p/Milwaukee-PACKOUT-Wall-and-Floor-Mounting-Plate-48-22-8485/310990289

I remember seeing some mounting this on the truck bed rail, how do you mount it? What hardware do you need? Also, what about the bottom half? Swinging?

 

Here it is:
https://www.tundras.com/threads/milwaukee-tools.150636/page-45#post-3846681
Because of the Renegade tonneau I used Integral Truck bedside panel drop bracket extenders to lower the mounting to the rails - https://integraltruck.com/products/...op-bracket-kits?_pos=1&_psq=drop&_ss=e&_v=1.0. Then, you can use any T-Slot fastener, such as

$20 RARAYC 6 PCS Bed Rail Accessories for Toyota Tacoma & Toyota Tundra

https://www.amazon.com/dp/B0BG7BMLX...04b4a&sp_csd=d2lkZ2V0TmFtZT1zcF9kZXRhaWw&th=1 or

$19 MELIPRON 10pcs T-Slot Nuts Fit for Toyota Tacoma & Tundra Pick Up Truck Bed Deck Rails 3/8"-16 Thread Bed T Slot

https://www.amazon.com/dp/B09Z8Q42D2 from Scamazon.

 

So, basically a back plate then the packout plate then the actual packout?

 

No back plate. T-Slots in the rails, Integral Truck drop brackets attached to T-Slots (not needed if you do not have a tonneau), then Packout plate attached to drop brackets. I have a Bed Rug and the Packout bottom fits snug to the Bed Rug. (If you have an open bed then Integral Truck sells locking plates. I only used the brackets and not the panel.) I used two large Packout wall plates https://www.homedepot.com/pep/Milwa...L5dHSMxklMPfEqKZ_wRoCG48QAvD_BwE&gclsrc=aw.ds. I can grab some close-up photos if you want.

 

Right, I was looking at the single panel since that's all I have at the moment.
I have the Retrax XR, and so my front side is not gonna happen, and I kinda wanted to mount it horizontal on the passenger side before the wheel well, but looking at what Integral truck is offering, looks like a back plate or just the drop bracket is enough?
These are just duplicate of what our Milwaukee packout panel you just linked, correct?
Reason I thought I needed this because of the bottom part might swing, but am I over thinking this?

 

Almost correct. You use the Integral panel instead of the Milwaukee wall plate Yes - But the difference is the Integral panel locks the packout box onto the panel.