What have you done to your 2.5 gen Tundra today?

If you have access to a table vise, it would make bending these plate much easier. They do not bend with just vise grip.. i had to cinch them down onto a table vise, while pulling toward me, hammer at the bend to get them to bend. That’s how hard and tough these plates are. My 2 light bars do not move.

 

Engine block heater kit arrived from Canada today with emailed instructions. Figured this might be helpful to someone. This kit is for model years ‘18-21, but there many other kits available.

PM me if you want details, it was $180 shipped to my door. Dealership parts department was excellent, fast with great customer service. Pass on everything I have.

 

I had the OEM Toyota All Weather mats in my truck before swapping to Husky X-Act Contour liners... I went with the Husky for the same reason mentioned earlier that I like the softer material vs WeatherTech. But I wouldn't say the Husky liners are to grippie (if that's a word lol), they have a nice grip without the rubber stick like the OEM mats. Since I have storage under my rear seat and the liner is cut to fit under that it's not easy to remove for cleaning so I just spray it with a cleaner and agitate with a brush then wipe off with a micro fiber cloth, wipes just fine.

 

I have them and like them. Hold up very well, 3 years in and still look brand new. As other stated [quoted below] a quick wipe down and you're good to go. Don't have much experience with Husky or OEM.

Yes, great coverage.

Agreed. Don't have to spend too much time cleaning them. I remove occasionally and give them a good scrub outside the vehicle. I found out that you don't use 303 products on them, makes them very slippery. Don't ask how I know lol.

 

I have no idea. Are you looking for one? I went with a Transfer Flow 47 Gal. tank and love it.

 

What all is involved in swapping them out from the under-seat vents?

 

The under-seat vents stay in place. Since you have the console with the vents already, you have all of the major pieces needed other than the duct that I have. Basically before you install the console, there is a hole that you cut in the duct forward of the console. I'll find my pics.

 

Do it.

 

Tempted......how hard is the install?
Send me the instructions.

 

since we're talking about AC and ducts- I'm tempted to get these off Etsy. Being in AZ, we use the ventilated seat a LOT. I think it would help.

https://www.etsy.com/listing/184344...ota-tundra-platinum-ac?ref=user_profile&frs=1

 

Holy crap, thank you for sharing this....

I am going to go check my truck and if it is the same I am going to make my own. If it is successful, I will share it here.

 

Did you use your OEM fuel pump and other parts?

 

After selling my 2011 rig back in 2023. I was considering going with the third gen until I realized they fumbled it and I wanted a 8 cyl. After some back I came across this monster. Hoping to have it delivered this weekend. Link is to the auction for the vehicles which shows you all of the pictures. I plan on getting new rims and tires. https://carsandbids.com/auctions/3ggkO4AP/2019-toyota-tundra-limited-crewmax-4x4

 

what in god awful hell did they do to that interior

 

Without clicking anything this def says Florida.

 

With all due respect...

 

That is by far the fanciest interior I've ever seen on one of these trucks

 

You will cut this piece out just inside the lip for the duct to slid into.

 

There's a whole lot of stuff going on with that thing. Doubt its worth $48K but just my opinion. I wonder if the PO named it Blueberry.

 

No leveling kit or lift or spacers. Is perfect and no rubbing

 

I was hoping you were wrong... unfortunately you are not.

 

Thats a lot of custom work :O

Hope you like it as it is! otherwise you'll be removing tons of stuff

 

Was Huggy Bear the previous owner? (Showing my age, I guess)

 

Had to put a new battery in. The old one took a shit. After talking to the guy at Auto Zone, I found out my old battery was still under warranty with about two months left. So, it was free!

 

I will take it. I just sent you a DM

 

I'd make sure any drug dogs don't come anywhere close to it. Or is that why it was at auction?

ETA: Never mind...

https://www.blessthisstuff.com/stuff/vehicles/cars/toyota-tundra-devolro/

 

Worth using Ravenol fluid or stick with Toy WS? https://www.blauparts.com/toyota-tundra-transmission-fluid-atf-change-kit-2015-21-6-spd.html (I understand I'd need more fluid for the larger pan...)

 

I used the Ravenol in my transfer case but used Toyota WS for my transmission service