WHAT HAVE YOU DONE TO YOUR 3RD GEN TUNDRA TODAY?

Iced down the whip. Used Adam's Advanced Graphene Ceramic. This stuff was very easy to use.

 

Do you have a part number for the button, i cannot find it. i'd like to order online.

 

I have wrap my calipers today with a reflective red vynil, looks unreal at night.

 

They almost look like they are glowing red hot! How does the vinyl hold up to the brake heat??

 

Yes, vynil is for high temperature

 

Assembled and installed a Smartcap EVOa

 

Here it is 84945-0C01 for the button, u will also need 81568-0C160 (this part will need to be modified)

 

What lift and tire size are you running, looks perfect for oem+ keeping the front mud flaps.

 

This is a great looking set-up!

 

Factory Lift, 285/65R20, Toyo Open Country ATIII.

Even though Toyota states that sized tire wont rub, they rub on the sway bar... I believe the TRD OR wheels have a different offset as compared to the typical factory wheel. I may try throwing on a small spacer to see if that helps. If not, maybe I'll change wheels down the road when these tires wear out.

 

Good to know. I have the nightshade 20s/stock tires and want to step down to 18s, and I'm also installing the trd front sway bar this week so thats good info about the bigger size tires rubbing. Could always throw some spacers on.

 

Decided to take the Blazer module back and ordered the Garmin PowerSwitch instead....I just couldn't resist the lure of using the truck screen to control stuff in Android Auto.

 

I installed the Fitcamx dash camera this weekend. Have an issue getting the smaller piece of the cover snapped back on, but I gave up knowing it would be coming back off once I get the cable to plugin to the OEM connector. Also not having much luck getting the rear camera cable hidden along the rear window.

 

I'm going to do a paint correction this Spring and try Adam's AGC too.

 

My installer said it wasn't too hard and it looks really good. It is a well made kit.

 

Spread my cheeks and paid for my reg renewal. $796

 

where do you live ??!!!!

 

I’ll give you a hint….

 

Toyota OEM recovery points and Talon’s garage catalytic converter shield installed. Next month will be full front ppf, full vehicle ceramic coating, and window tint!

 

just one

 

Installed my skid plate today. It's a trd clone and required very minimal fitment of the back bolt holes, but it saved me $250 for other mods. It is the same 1/4 inch aluminum which should be fine, as I don't overland or heavy offroad.

 

Agreed, I like the way it fits the Tundra!

 

Here in Virginia we have to pay our personal property tax on our vehicles. My 2024 1794 Limited Edition cost me over $1,500 in tax.

 

sorry have to ask again, are you saying that is the factory 3" lift, or stock 0 lift...man it looks like it sits high.

 

Definitely the 3" lift. You can see the red springs and TRD UCAs

 

What are you having an issue with ? I installed mine and was fairly easy ... which rear window do you have ?? Full slide, center slide ? or no slide ?

 

thats what i thought, just wasn't sure if my eyes were going bad haha.

 

Do you have more pics? How did you hook it all up?
Thanks

 

Was $783 for me :’)

 

Where did you get the reflective red vinyl? It looks sharp. I was thinking of doing mine in red as well.