Milwaukee Tools

Is that for landscaping or airport security?

 

I did try the chat here’s what I got. Got basically the same line from a store manager too. Might try again!

 

@T-Rex266 in all your wisdom do you know if they offered a special buy for the 1/2” m12 stubby?

 

That is what I need for my gut - an anti-sag kit

 

Everything to solve the problem results in hurt! Walk, run, stair stepper, treadmill, roman chair, etc.

 

My chargers will charge two batteries simultaneously, but will only charge one of them at a time at supercharger speeds…

 

I picked up some more pack out containers and a rechargeable "USB Rover" light!

https://www.milwaukeetool.ca/products/2112-21

I can't believe how many of these red tools I have collected over the years! I am trying to acquire as many Hitli tools as I have in the red brand!

 

One of my favorite lights

 

A question on the stubby impact wrenches - are the 1/2" drive bodies the same size as the 3/8" drive? I ha e a pretty decent collection of 1/2" drive impact sockets and the mid-torque impact. Id benefit from the smaller body, but would rather not buy another set of sockets.

 

Ya they look like crap! I am testing the battery life now to see if it will give me at least an hour of run time on high!

The clip does seem fragile and I will be careful with it. I will only need it to stick to our control panels while working on the wiring. If the clip breaks, I can stick a rare earth magnet to the side of it.

It might end up going back to the store!

 

https://www.youtube.com/watch?v=Y-vVoIwTrUM
USA Baby

 

I was able to test the run time of this light on high and got 3 hours out of it. That is pretty good considering it was getting warm to the touch. I didn't time the recharge time but had it running on USB C off the laptop. I think 3 hours is pretty decent runtime. Probably much longer on the low power setting.

 

Pretty sure they are, just a different anvil. I was hot on the 3/8 but now I’m thinking the same way you are since most all my impact sockets are 1/2.

 

Not trying to derail the M thread but this is the socket set I keep in my truck. Has adapter to go from 3/8 up to 1/2” (plus added one to go down) and between all the 3/8 and 1/2 sockets in this set there are virtually no skips. Coupled with their known reliability, blow mold case, and lifetime warranty makes it a no brainer for the price. Anyway, figured I’d throw it out there as an option for ya..

 

If I went 3/8 I’d go with this but alas I refuse to pay full retail for the stubby
https://www.homedepot.com/p/Milwaukee-SHOCKWAVE-3-8-in-Drive-SAE-and-Metric-6-Point-Impact-Socket-Set-43-Piece-49-66-7009/316467306

Also being realistic, I have about any 1/2 impact I’d need including swivels, short, deep, etc. so do I really need to buy a set of 3/8?

 

Yes

 

Kudos to Milwaukee! Put in a warranty request just to see if they would send me the new style anvil adapters for my Insider ratchet since I bought mine early on and it came with the old style ones. Took a few weeks but sure enough, they sent them to me and I just got em.

 

I mean, why not?

 

Damn y’all are a bad influence. Come to think of it I do have a 3/8 Aircat stubby I’ve barely used….lol